How to install an IPv4 address on my Raspian

From EN Ikoula wiki
Revision as of 12:22, 27 March 2020 by Ttomaszewski7090c (talk | contribs) (Created page with "{{#seo: |title=Your page title |title_mode=append |keywords=these,are,your,keywords |description=How to install an IPv4 address on my Raspian |image=Uploaded_file.png |image_a...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
⧼vector-jumptonavigation⧽ ⧼vector-jumptosearch⧽

Problem:

I have ordered an additional IPv4 address for my Raspberry Pi, however I can not reach it after delivery.

Solution:
It is a normal behaviour, IKOULA provides you an additional IPv4 address, but does not configure it on your server:

  • You have to connect via IPv6 :
  • Edit the network configuration file and and add this block (to modify with your IP, including the gateway line)
nano /etc/network/interfaces

auto eth0:1
iface eth0:1 inet static
address 178.170.Y.X
netmask 24
gateway 178.170.Y.1
dns-nameservers 213.246.33.144
  • Reboot the network service
systemctl restart networking.service
  • Check the IP statue by executing:
ip addr show
  • You should see:
eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
   link/ether dc:a6:32:5e:b8:f3 brd ff:ff:ff:ff:ff:ff
   inet 178.170.10.14/24 brd 178.170.10.255 scope global eth0:1
   inet6 2a00:c70:130:1::110/64 scope global
      valid_lft forever preferred_lft forever
  • You are now able to connect to your server via IPv4

/!\ There may be an error message indicating that the Eth0 interface is not created, because it has not fully restarted. After rebooting, this message should be gone. /!\

Retrieved from "https://en-wiki.ikoula.com/index.php?title=How_to_install_an_IPv4_address_on_my_Raspian&oldid=10346"